logo SPECIALIZED IN RF CONNECTION MANUFACTURE

Service Hotline

0086(755)-66827658

Demystifying the backend connection of the RF connector

Time:2018-11-29

RF connector connection may be known to many people, such as snap-on, threaded, blind-plug, etc., but the connection method of the back-end may not be known. This is also a very important piece of knowledge of the RF connector. Will have a certain impact on the product, let Xiaotian to tell everyone!

There are three types of backend connections for RF connectors:


One is the connecting panel, which can be divided into two types of connection, which are locked by screws or nut washers.


1, panel perforation


2, the veneer


The second is to connect cables, which can be divided into the following five wiring methods.


1, the inner and outer conductors are crimped


2, the inner conductor is crimped, and the outer conductor is welded


3, the inner conductor is welded, and the outer conductor is crimped


4, the inner conductor is welded, and the outer conductor is screwed


5, the inner conductor is crimped, and the outer conductor is screwed


    .....


The third is to connect the PCB, which can be divided into four connection methods:


1, piercing welding


2, card board welding


3, shrapnel crimp


4, plate welding

Tiankele connector manufacturers are committed to the forefront of RF connector development, with a complete industrial chain, a number of advanced laboratories, three quality inspections, with an excellent rate of 99.99% and hundreds of business units at home and abroad to reach dozens of Year of cooperation! If you have any questions in this area that need to be resolved, please call for free to get the solution 13684973846

Copyright http://www.twl-link.cn/ If you need to reprint, please indicate the source!

ABOUT

SKYPE

CALL

PRODUCT

CONTACT